Labor

A comprehensive sealed system repair is performed on average within four hours of onsite labor.  One or two technicians will perform the work.  The technicians will perform the following, but not limited to, services at the location:

• Installation of the service recovery valves
• Refrigerant recovery and removal
• Extraction and disposal of defective sealed system component parts; for example, the compressor, run capacitor, overload relays, etc.
• Seal and close off oil ports, grommet insulators, etc.
• Nitrogen purge and seal pressure test
• Refrigerant charge and restart of the system
• As needed, the installation of all new applicable sealed system components: compressor, re-sweat and seal system, live flame charge, all seal couplings, etc.

Parts

This is a list of the parts that will be replaced during this procedure: 

• Compressor
• Overload relay, run capacitor, start relay, Schrader valves, service valves, cap seals, sweat fittings, silver solder, braising rod and flux, sand cloth, filter dryer, evaporator coil, accumulator, condensing motor, refrigerant recovery bag, nitrogen, acetylene, and full system charge of the appropriate refrigerant.
• If applicable; drain loop assembly, plumbing assembly heat exchanger/capillary line.

Warranty

There is a five year warranty on the compressor.  All other component parts and labor hold a one year warranty.  All travel charges are covered under warranty as well.